Subject: there has to be a better way
From: Rotary Engine
Date: 10/31/2006, 9:14 AM
To: AA-me




        Paul
        McMaster definitely has some tubing that will work. The telescoping
        hobby aluminum or brass as Aubrey suggested will probably be a
        really nice and cheap (not to mention light weight) way to go.
        The tension bolt is .375 or 3/8 so I.D. of the tubing should be
        around .400 maybe allow some room for silicone. I don't think the
        tubing actually has to touch the walls of the housing,Iron or
        aluminum. Of course now,you have to make sure that the
   concentrically
        is fairly good as you will be turning the entire assembly in
   the hole.
        OR maybe use a light coat of Vaseline on the tension bolt and when
        the silicone cures the bolt will simply turn isinde the whole
        assembly that's if the concentrically is to far off. Otherwise it
        may be like a cam of sorts. Follow Me on that????

        Tony

        Yes getting it to go in might be a REAL problem if it
        is NOT concentric.

        I think you would be better off just wrapping it with
        silicone tape.

        But let us know success or failure. We learn from mistakes
        as well as successes.
        --
        Paul Lamar ...No rotor no motor

   Paul, and Tony,
   I have a suggestion for you. Since the need is to dampen the silicone
   doesn't need to adhere to the housings, I suggest you take a tube and
   cut it in two parts. Coat the tension bolt with hi-temp silicone
   liberaly, Take a tube with an id about the same as the diameter of the
   housing hole and enclose the bolt. Cast the bolt with silicone. Tape the
   bolts and tubes up and let set for a few days. The silicone will help
   dampen vibration even if it's not a press fit in the holes. Oh I almost
   forgot, remove the tubing before inserting the bolt/silicone.
   Bill Jepson



That sounds like an interesting idea, but...  Let's just forget about
all of the sticky stuff.  I can't see any reason that it's actually
needed.  We're looking for damping, right?  It seems that all we need to
do is to keep the bolt from flopping around when the engine is operating
at the bolt's resonant frequency.  I would think that you could just
select a some hose that won't burn/deteriorate at the expected operating
temps, and which fits the bolt slightly snugly.  Cut pieces that are an
inch or two long and slide them onto the bolt to somewhere around the
middle of the bolt.  Install the bolts and be done.  If you're concerned
about the hose sliding down the tube while the engine is operating, dab
a little RTV at each end of the piece of hose.  The RTV doesn't have to
stick to the hose, just the bolt, as long as you put a dab at each end
of the piece of hose.

McMaster-Carr has some 3/8" ID x 1/32" wall plastic hose with teflon
that's pressure rated to a temperature of 400F.  Search for  52355K15


Regards,

Matt-



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.