Here is the intake manifold that I've had Ed weld up for me.  Overall,
it is a very tight profile.  I previously sent pix on the porting that
is present in the flat plate under the plenum.

I'm looking into getting an engine dyno'd with this, to see how well
such a short intake will work.  BTW, that is a 70 mm Ford Mustang 5.0
throttle body, because I'm not confident with a controller for the FBW
Mazda TB, although the bolt holes are the same pattern.

Scott Gettings

I would very interested in the dyno curves Scott.
Thanks for doing that.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.