paul

Just some pics of the motor preassembled. Everything is torqued down.
I'm going to safety wire everything. As you can see the tension bolts
where drilled as well. I have new titanium studs but I'm not sure if
I'm going to use them or not. I want to run it on the stand for a bit
and get it tuned before I start changing tension bolts.

Tony

Tony,
That blue paint job is fantastic.  It looks like the safety wire on the
two lower bolts should be redone to pull CW on the bolt heads, however.

Aubrey

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.