> paul
>
> Just some pics of the motor preassembled. Everything is torqued down.
> I'm going to safety wire everything. As you can see the tension bolts
> where drilled as well. I have new titanium studs but I'm not sure if
> I'm going to use them or not. I want to run it on the stand for a bit
> and get it tuned before I start changing tension bolts.
>
> Tony


Tony,
That blue paint job is fantastic.  It looks like the safety wire on the
two lower bolts should be redone to pull CW on the bolt heads, however.

Aubrey

Thanks Aubrey

That's actually powdercoat it's called tiger blue it's shot in two parts
first is a silver then a transparent blue it looks like it has metal
flakes in it. cost me $350.00 bucks not cheap but looks great. As far
as the safety wire goes you are correct it does need to be redone.

Tony

Some people spend that much on their whole engine :)

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.