paul

Just some pics of the motor preassembled. Everything is torqued down.
I'm going to safety wire everything. As you can see the tension bolts
where drilled as well. I have new titanium studs but I'm not sure if
I'm going to use them or not. I want to run it on the stand for a bit
and get it tuned before I start changing tension bolts.

Tony

Looks nice. Are you sure you have your safety wires right ?

John

Sorry, as I read on further I noticed someone else had mentioned your wire
orientation already. I get so excited when I see something like that and I
have to pipe up right away. I usually feel like a kid amongst his betters
and elders listening in on lofty discussions. Of course I am likely to learn
something listening to the intellectual giants on this list. Again that
engine looks great.

John


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.