This is a VERY simple system. No computer, no sensors, no
floats, no venturi, no fuel injectors, no nothing. Just very
low pressure fuel. The fuel orifice area simply increases with
the air passage area increase. Bigger fuel hole bigger air hole.
There is another simple series valve that controls leaning.
I think I have figured out how to do this with our slide
throttle. No fuel injectors required. In fact other than
a bit of plumbing there are no additional parts.
Patent applied for :)
Paul Lamar
Sorry to say Paul that LECTRON carburators probably beat you to that
patent Paul. They did an entire series of single needle & single jet
carbs 15 or 20 years ago. They were a nice system too. A carefully
ground needle handled metering. They had both float bowl and diaphram.
(also called pumper carbs, using a vacuum pulse powered pump) The pumper
style would fit your discription almost perfectly.
Bill Jepson
Nope no needles :) I'll give you 30 seconds on how I am going
to do it :)
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.