Subject: Throttle cable anchor bracket for slide throttle
From: Rotary Engine
Date: 11/8/2006, 1:47 PM
To: AA-me

    > OK Doc based on the dimensions Mark sent me
    > we can shorten it about 1.15 inches.
    > Move the engine forward an inch and now you
    > have about two inches of clearance.
    > You will still have 3 inches of slide travel.
    >
    > The motor mount is always the last thing you
    > design anyway. You need to weigh all parts first
    > and mock up the entire engine first or do accurate
    > and scale 3D's.
    > --
    > Paul Lamar ...No rotor no motor.

   Is it possible to reverse the direction the slide throttle travels
   with the use of a bell crank?  Jerry

   ------------------------------

   Sure but why would you want to unless it is a pusher?
   In the case of the pusher just use a 180 degree bend
   in the throttle cable up near the cockpit.

   Pushing the throttle knob in opens it up increasing
   the power. The last time I checked my 182 worked like that.

   One of the safety features is the extreme simplicity
   of the throttle control. It could be replace by a simple
   steel rod if it came out of the instrument panel in
   a convenient place.

   Paul Lamar ...No rotor no motor.



Jerry-

Something else to think of...  I  am not sure whether a bellcrank  would
make things better, or worse, when it comes to the force necessary to
move the throttle plate.  As I found in mine, with the engine running
the throttle was not the easiest thing in the world to move.  I freely
admit that I did not have the cable assembly well secured along it's
length, and thus I may well have been causing my own problem.  Because I
had to pull the engine off the airplane again so quickly, I did not get
a lot of debug time with the throttle assembly to try to resolve the
force issue.

In any case - if a bellcrank were a necessity, I would try to design it
such that it allowed maximum travel of the throttle cable & translated
this into exactly the throw of the throttle plate (this throw is less
that the cable would allow).  This should put the cable at a slight
mechanical advantage -- perhaps enough to cancel out the friction of the
bellcrank itself.

Once my engine returns from CA, I'll be resuming my investigations of
throttle plate forces & will duly pass along what I learn.

BTW -- Paul, I am beginning to think I was running the engine with the
leading & trailing plug wires swapped.  I'll get out my circuit tester &
check it out next time I'm at the hangar.  I wonder if that might
explain some of the more-than-typical roughness I was experiencing.

mrs

It is a possibility. I'll come over when you get the engine back.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.