Subject: Combination slide throttle and carburator
From: Rotary Engine
Date: 11/9/2006, 3:22 PM
To: AA-me



       This is a VERY simple system. No computer, no sensors, no
       floats, no venturi, no fuel injectors, no nothing. Just very
       low pressure fuel. The fuel orifice area simply increases with
       the air passage area increase. Bigger fuel hole bigger air hole.
       There is another simple series valve that controls leaning.
       Paul Lamar

   Paul,
      FWIW I believe the Aero-Carb violates the Lectron patents, if
   they are
   still active. The Lectron I worked with used a square slide like a
   slide
   throttle, but were built on a single bore using a return spring and pull
   cable.
   Bill Jepson

   http://www.aeroconversions.com/carb_specs.html


   Times up.
   Here it is. Super simple. A series of progressively larger
   feed holes in the Teflon slide communicating a with a fixed
   larger fuel hole in the aluminum spacer.

   Patent applied for :)
   -- Paul Lamar ...No rotor no motor.

   Paul,
   Sorry for not getting back yesterday, went to bed. The hole idea is ok
   but you will have some problems. Kind of like a digital drive for an
   analog circuit? An alternate idea would be to have a single feed hole
   and a shallow tapered wedge connected to the feed on the end. easier to
   make too. (some of the holes would be reeeeeelly small) Tell me what you
   think.
   Bill Jepson

   Good idea Bill. Cheaper than my system. Less cost to make.
   Will work better. With an NC mill program you could vary the slope
   of the ramp.

   Paul Lamar ...No rotor no motor.

   Here is the $7 mixture control valve from Home Depot.

   This is a major break through in aircraft fuel systems.
   Simple systems like this work because the aircraft
   engine has simple requirements. The load is fixed
   and the RPM is constant. The only real reason for a complicated
   carb or EFI system is automatic mixture control.
   Since pilots are used to setting the mixture manually
   it makes no sense to have an automatic mixture control
   as well.

   With an EFI system you are in a world of hurt if your
   alternator fails. You have a limited amount of time
   before your EFI system stops as well as your engine.
   That is due to the high current requirements of high
   pressure fuel pumps. In this case you could use a hand
   pump to keep fuel supplied to a small sump tank mounted
   up under the cowl.

   The cost of this system everything included is less
   than about $200.  The cost of an EFI system everything
   included is well over a $1000.

   Not to mention the intrinsic high power of a slide throttle
   P-port engine.

   Klause Savier has run his O-200 with something similar as a back
   up to a Posa Carb.

   BTW the Wright brothers used something similar.

   Paul Lamar ...No rotor no motor.


Hey Paul,

I am not completely clear on how this works..  I can see that throttle
position modulates fuel delivery, but does mass airflow also?  Do you
need a venturi of sorts to control fuel flow while the slide is
completely open?


Regards,

Matt-

Nope. Constant dribble system.  You adjust the amount of dribble
with the Home Depot 1/4 inch pipe ball valve. One advantage
over most EFI systems is you can use two Home Depot valves
and adjust the mixture on each rotor individually according
to their EGTs.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.