Subject: Combination slide throttle and carburetor
From: Rotary Engine
Date: 11/9/2006, 3:37 PM
To: AA-me


Good idea Bill. Cheaper than my system. Less cost to make.
Will work better. With an NC mill program you could vary the slope
of the ramp.

Paul Lamar ...No rotor no motor.
<slide.jpg>

Hi Paul and Bill,
I have seen this idea before, years ago, on a  two stroke M/C engine,
Puch, as I recall. I think the T/B had just the hole into the throttle
bore and the sliding block had the tapered slot, this makes mixture
adjustment easier by just  exchanging the sliding block with one with a
different slot size or slope. Same idea as having a range of needles
for the Bing;  you have a range of tapered slots.

I can see easy inflight mixture control with this idea;  the threaded
pull cable has a nut that, when turned, varies the position of the
block with respect to the the hole, while the throttle remains set.

These types of carb generally like low fuel pressure, about 2- 4 psi,
so varying the fuel pressure in flight may be simpler for mixture
control.

BR, Dave McC



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.