Subject: Combination slied throttle and carburator
From: Rotary Engine
Date: 11/9/2006, 8:37 AM
To: AA-me


  This is a VERY simple system. No computer, no sensors, no
  floats, no venturi, no fuel injectors, no nothing. Just very
  low pressure fuel. The fuel orifice area simply increases with
  the air passage area increase. Bigger fuel hole bigger air hole.
  There is another simple series valve that controls leaning.
  Paul Lamar

Paul,
 FWIW I believe the Aero-Carb violates the Lectron patents, if they are
still active. The Lectron I worked with used a square slide like a slide
throttle, but were built on a single bore using a return spring and pull
cable.
Bill Jepson

Times up.
Here it is. Super simple. A series of progressively larger
feed holes in the Teflon slide communicating a with a fixed
larger fuel hole in the aluminum spacer.

Patent applied for :)
-- Paul Lamar ...No rotor no motor.

Paul,
Sorry for not getting back yesterday, went to bed. The hole idea is ok
but you will have some problems. Kind of like a digital drive for an
analog circuit? An alternate idea would be to have a single feed hole
and a shallow tapered wedge connected to the feed on the end. easier to
make too. (some of the holes would be reeeeeelly small) Tell me what you
think.
Bill Jepson

Good idea Bill. Cheaper than my system. Less cost to make.
Will work better. With an NC mill program you could vary the slope
of the ramp.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.