Hi Bill,
I like the idea that the sliding block does not have the float valve
that worried you. If it worries you, then it worries me!
Does the Lectron have a float bowl?
Dave McC
Dave,
The Lectron has a conventional float bowl. The unique part of the carb
is that it uses a single, specially tapered central needle for all fuel
distribution. (idle to WOT) This is why I believe Pauls idea about
the Slide Throttle carburetor could be made to work. The only concern I
have for float systems is that they must be kept supplied with fresh
CLEAN fuel. There are many good filters, and running one is needed on a
carb system. You need to fly regularly to be sure the fuel doesn't get
old and produce "gum" by having the light ends evaporate off.
Bill Jepson
This system is easy enough to check on the bench.
You set it up with a typical head of fuel and
use a calibrated beaker to measure the flow as a function
of slide position. Same thing goes for the leaning valve.
One can always heat the slide plates to 200 F with
a hot air blower. I also have a vacuum pump that can
be used.
> Paul Lamar
The two strokers even have a small electric coil around the
venturi for heat. I have seen them for sale on ebay.
The mixture control on the Aerocarb is extremely simple,
maybe even less than $7. It is a needle valve with the
seat bored into the case at the inlet fitting. It can rotate
through a quarter arc (90 degrees) with a lever attached
to allow 2.5" of movement. My vernier mixture control
makes very fine adjustments.
Terry Adams
The simplicity is stunning! Can be easily retrofitted
to our current slide throttle design.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.