Subject: Combination slide throttle and carburetor
From: Rotary Engine
Date: 11/10/2006, 9:18 PM
To: AA-me



Folks,

Have been out of town so am not exactly sure how we got here but have to
say this is looking pretty ingenious.

One question I have is how well the fuel will atomize and evenly
distribute just dribbling into the side of the air flow.  If there was a
long way between the slide and the intake port, this would be a mute
point but my understanding it that is should kept close.

Perhaps an internal tube to get the fuel closer to the center of the
flow stream or even another fuel entry point?  Just a thought.....

Regardless, a very simple, robust system for our needs.   Good job!

Steve Webre
Broussard, LA

We are going to try adding a little heat to cause
the fuel to vaporize. Some where around 150 F should work.

Paul Lamar

Gasoline heat of vaporization ~ 170 BTU/#, at a fuel burn rate of 10
gallons/hour (60 #/hour), you will need 170*60 = 10,200Btu/hour of heat
transferred to the gasoline at that point in the manifold. This is going to
be more than just conduction from the warm engine to the manifold, you will
need a fairly significant heat source.

Bill Schertz

Thanks Bill. We will pump some hot air heat up from the exhaust
manifold.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.