Here is the $7 mixture control valve from Home Depot.
Paul Lamar
You do know they have ball valves in pvc that are much lighter and
work
better, don't you? <g> Much cheaper too. <vbg>
jofarr, soddy tn
Yes but I don't know the long term effects of gasoline
on PVC. There are bronze valves with chrome balls
running in Teflon seats. Can't get much better than
that. Also $7 each is very cheap for an aircraft
part.
Paul Lamar ...No rotor no motor.
The Cole-Palmer website
http://www.coleparmer.com/techinfo/ChemCompResults.asp
rates PVC w/ unleaded gasoline as
Fair -- Moderate Effect, not recommended
for continuous use. Softening, loss of strength,
swelling may occur.
rating for leaded gasoline:
B = Good -- Minor Effect, slight corrosion
or discoloration.
I use a PVC tube for unleaded gasoline transfer. After one year of use
it is discolored. It is a gravity flow installation, so I do not know
if any loss of strength has occurred.
Doc Custer
Retired software engineer and sometime Audiologist
Building RV9-A. Fuselage
This is a somewhat clearer 3D of the over all system.
This would be duplicated for each rotor.
If one leaning valve is used for each rotor
the exact mixture can be set for each rotor
based on the EGT numbers for that rotor.
Something most EFI systems cannot do.
This can be easily retrofitted to any of our
recent slide throttle designs.
--
Paul Lamar ...No rotor no motor.
Paul,
Oh good drawing! I was a little slow on the uptake of this idea:) Now I
see now what you are talking about. Since you are using the slide as a
metering ramp and the spacer as a fuel inlet, I imagine you could also use
the rear plate as an inlet and put the ramp in the back central vertical
face of the slide. That way you could get the fuel to enter at the optimum
location for idle to WOT. IE the side of the hole.
DougFir
I thought about doing it that way but decided against it
for structural reasons. There are small clearances all
around the slide so once the fuel gets out of the ramp
near the feed hole it will be everywhere inside the slide
throttle.
If the mixture becomes way too rich the bottom of the slide
throttle could fill with raw fuel until the level gets up
to the bottom of the runner hole and then it will be
sucked into the engine. I can imagine an equilibrium condition
where raw fuel is always present in the bottom 15% of the slide
throttle.
I updated the web site with this 3D drawing.
For 90% of what we do this system can cut the overall cost
of the engine by $1000 AND produce 50 MORE HP.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.