Paul,

One company in South California, its eBay name is "turbos_r_us" could clip
my turbine wheel for me.  There are turbine wheels on his eBay site clipped
at 5, 10 or15 degrees.  Do you think I should have my turbine wheel clipped
at 15 degrees?  My turbo is the Mazda 1989 one.

Thanks
Rino

I am not sure that will work. It sounds like it will.
Most people have gone to a bigger compressor.
If clipping works to slow the turbine that would
be a lot cheaper to do. It also sounds like it might
reduce the centrifugal loads on the blades which would
be an improvement. Do you have a sketch on how they
are going to clip the blades? 15 degrees does not mean
much to me.

I see there is a turbos_R_us in Australia.

Do you have a web site for these people in So Cal?
Or an post address or phone number? I can go by and see the
shop.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.