Subject: Combination slide throttle and carburator (And Magneto)
From: Rotary Engine
Date: 11/13/2006, 9:56 PM
To: AA-me



   Ever fly a carb aircraft piston engine? Lots of mixture
   adjustments are required. Most of the pilots successfully flying
   them are not flight engineers.

   The high quality ball valve shown has a one inch circumferential
   travel. If you lengthened the lever to 3 inches, which
   is a stock mixture control cable travel, fine adjustments are possible.
   Mixture controls have vernier adjustments.

   We have had several problems with EFI systems. There is a lot more
   to fail. We had one total electrical failure crash that would not have
   happened if they had a carb and mag. We had another in flight fire that
   burned the wires going to the electrical fuel injectors causing
   the engine to quit. Fortunately the guy was on short final.

   I had a boost pump fail in a Mooney and the injection engine quit with a
   bang.
   Parts of the vanes made it to the mechanical pump and caused it
   to fail. Fortunately I was over an airport and got it back on
   the ground dead stick.

   AN fuel plumbing is very reliable.

   Dual alternators and batteries are heavy and costly.

   My guess is the most reliable aircraft engine is the simplest and
   equipped
   with carbs and magnetos not counting turbines. They are also
   easy to maintain, inspect and fix by non computer gurus.

   Paul Lamar ...No rotor no motor.

   Paul,

   These are very good arguments in favor of a simple carb and magneto.

   For a magneto, perhaps a motorcycle-type setup could be fashioned,
   using
   generating coils mounted around the flywheel. The coils are excited by
   magnets permanently mounted in the flywheel. You could have a separate
   set of coils for each spark plug, so you have the equivalent of dual
   magnetos.

   The Rotax magneto system is based on this architecture and works very
   reliably. A third set of coils goes to a rectifier and provides charging
   for the battery. So you don't even need a belt-driven alternator if
   your
   power requirements are modest. If you need more power, just add an
   alternator.

   I think Revmaster also uses something like this. And some VW and Corvair
   powered airplane builders use a similar setup with parts from a Harley
   dynamo similarly mounted to the crankshaft.

   With this magneto setup you will almost always have spark as long as
   your engine is turning. You can't say that about an alternator system,
   even if you have dual buses and alternators -- there are still possible
   failure modes, with wiring, belts, control boxes, etc.



   Regards,

   Gordon.



This distributorless coil ignitions sounds very cleaver, but I wonder if
there is a way to get such a system to work on a rotary engine..  In a
conventional 4 stroke engine, you get wasted spark, and off the top of
my head, on a 2 stroke, you use every spark generated by such a system.
I have a sense that the rotary timing needs to be different - not synced
with the e-shaft, but with each rotor.

We have discussed the flywheel/driveplate integrated alternator in the
past, and I still think it's the way to go...


Matt-

It syncs with the e-shaft no problem Matt.
One firing event every 180 degrees. One event for each rotor.
Two sparks per event. Four sparks total.
If the coils had enough turns to generate
300 volts you could have four capacitor discharge systems.
You would need four external coils and four FET's to fire
the caps.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.