Subject: Combination slide throttle and carburator (Atomization)
From: Rotary Engine
Date: 11/14/2006, 11:28 PM
To: AA-me


   snip...


   Well one thing is the Ellison has holes in one side of
   the needle only. The needle rotates to change the mixture.

   To make my original system more like the Ellison all the holes
   in the Teflon would have to be very small and be the same size.
   A slot in the spacer would open more and more holes to the fuel
   port as the the slide throttle was opened. I'll do a 3D soon.

   I'll be at Mazdatrix tomorrow working on Marks P-port
   engine until about 4 PM.

   Paul Lamar ...No rotor no motor.

   Paul,

   Yes, that's a very clever way to adjust the mixture. As the spray
   bar is turned, some of the holes turn away from the vacuum side and
   stop spraying fuel so the mixture is leaned.

   This wouldn't work obviously with your idea, but you have the ball
   valve to control fuel flow for leaning.

   The way you just described it sounds very good, with lots of small
   holes in the Teflon and a slot in the aluminum spacer. I hope you
   draw a picture.

   The Ellison still has an advantage in that the fuel is sprayed into
   the direction of the airflow, instead of at 90 degrees. However,
   with your system you don't have a spray bar or anything else inside
   the throat to obstruct the flow.

   It is a pretty neat idea and I hope someone tries to make a
   prototype to see how well it will work.

   As for fuel leakage, I wonder if the part of the slide where the
   fuel comes through could be sealed some way? Or just seal the
   outside perimeter of the whole thing with gaskets or O-ring?


   Regards,

   Gordon.



I recommend that people seal the whole slide with 1/64th thick
(16 thou...016") gasket material. Obtainable from McMaster Carr. You
don't want fuel dripping on your cracked exhaust manifold.
The gasket material also supplies the slide clearance
for smooth operation. Speaking of which you can get
14" x 15" Teflon coated steel backing cookie sheets in Walmart
for about $5 that will reduce the friction to half of standard.
Enough for both sides of the slide.

Teflon on Teflon is twice as slippery :)

If you don't want to do that McMaster Carr also sells
thin Teflon sheeting etched on one side suitable
for bonding to aluminum with epoxy.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.