I do not think the slot tapered in just the one direction will give the
metering needed. I think it might work better also tapered in this
direction also. Sorry I don't have Rhino and to much to draw the other
taper in solids.
Richard Konnen
Hard to machine manually.
--
Paul Lamar ...No rotor no motor.
Mark W wrote:
You could do it with a V point engraving bit. This will give you a
triangular groove. I was wondering whether it might not be better to move
the metering groove from the Teflon to the aluminum spacer. I haven't
machined Teflon, but would imagine it is easier to engrave a precise
repeatable metering groove into Aluminum.
I wonder whether some sort of fixed idle jet would improve the design, or
just add unnecessary complication.
I can't see how blowing hot air over the throttle body is going to make a
significant difference to the vaporisation of the fuel induced to the air
stream. A 2" diameter pipe with 1" in length heated externally is a fair
jump from a effective heat exchanger.
Mark W.
Heated intake manifolds have been around for 100 years.
there is no question that it works to vaporize fuel.
If you look into an intake runner while the engine is
running you see a mixture of vapor and tiny droplets
of fuel bouncing around. Some of it hovers just out
side the entrance to the runner.
If one of these droplets were to come in contact with a
hot surface it would instantly vaporize.
I the slide throttle you can see some of the fuel droplets
congregating around the junction of the partially opened
slide and the runner opening so some of the fuel is indeed
in contact with both the slide and the inner wall of the runners.
--
Paul Lamar ...No rotor no motor.
Putting the Metering taper out on the spacer might be also a good idea for
the prototyping phase. That way while experimenting to find the optimal
shape, the only part which needed replacement would be a 3/8" by 1/2" piece
of aluminum bar stock.
Mark
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.