I am about to upload this to the web site.
http://www.rotaryeng.net/intake.html

Does anybody want to comment?
Are there any questions?

Paul Lamar ...No rotor no motor.


Paul,

 This will be very helpful.  Just one nit:  "Dremal" should be "Dremel"

Mark

Thanks Mark.

I also forgot to mention about assembling the engine with
out e-shaft and rotors and pressure testing the coolant
system to 30 psi to check for leaks. However if this is done
right the large area of JB Weld bonded to the vertical walls
of the water jacket make coolant leaks unlikely.

Anybody else have any comments?

Paul Lamar ...No rotor no motor.

I believe in line 11 'oxidize' should be 'oxidizes'.

Also, the sentence that follows might be clearer to some if it read 'Heat
the JB Weld tubes in 150 F hot water just before mixing to reduce its
viscosity so it will flow into crevices.'

Bill Garrett

Thanks Bill. Better sentence construct.