Subject: Aspect Ratio (for lack of a better term)
From: Rotary Engine
Date: 11/23/2006, 7:01 AM
To: AA-me


             Hey Paul,

             My buddy and I were talking about BD5's (not a good idea -
        Hah!), and
             the discussion reminded me of that little Wankel Cart engine
        that was
             mentioned here a while back.

             http://www.nova-racing.com/nova_gb/index.htm

             I started pondering making one of these things as a two
   rotor -
        seems
             perfect - starts out water cooled and it looks like it
   might be
        p-port.
             The only thing I think I don't like are the roller bearings..

             The thing that stuck out when looking at the pics is that the
        rotor is
             so wide compared to it's other dimensions.



   http://www.nova-racing.com/nova_gb/Preise/Einzelteile_Orig/XN079%7E6.JPG

             I imagine this is how the 16B rotors might look...

             I think trying to convert one of these to a two rotor might be
             preferable to converting a 13B to a single rotor, and
   might end
        up in a
             similar (slightly lesser) horsepower range. A complete
   single rotor
             weighs less than 40lbs. It seems that a 92hp 2 rotor might
        weigh around
             75lbs - light! A 90hp Continental weighs 180lbs+..


             Matt-

             Yes it sounds like a better idea than a one rotor 13B.

             --
             Paul Lamar ...No rotor no motor.


             Matt,

             That's a nice little engine. How would you combine two of
   them,
        bolt
             the shafts to one another?

             What about the crankcase intake? Wouldn't that be in the
   way to
             bolting them together end-to-end?

             The specs say 31 kilowatt, which is 41 hp, so two would be
   82 hp.


             Regards,

             Gordon.


   Gordon,

   I was thinking that an intermediate housing would need to be developed,
   along with a custom e-shaft.

   The description of the intake seems somewhat vague..  I agree that it
   must have a side port as currently configured, but the description talks
   about a 2nd port opened above a 5500rpm.  It would be slick if that were
   on the rotor housing (p-port) instead of the end housing.  Even if both
   ports are on the end, a p-port might still be possible - just like on a
   13b.  At least it isn't charge-cooled..

   I see several values of power bandied about on their page..  One link
   says 48hp, another says 41(.5) and the graph shows a peak of about
   45.5hp (above 8000rpm)..  I think it all depends on the RPM used.


   Matt-

   It is charged cooled Matt. You can tell by looking at the
   seals picture. I think the second port is a p-port.

   --
   Paul Lamar ...No rotor no motor.



Okay Paul,

Thanks.  What are you looking at on the rotor?  Is it the big hole
through the rotor just behind the apex seal?


Matt-

Yes. I thought I had some diagrams on charge cooling but I searched
the web to no avail. Any body have any illustrations on charge
cooling?
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.