Subject: Ford psru parts & how they are used.
From: Rotary Engine
Date: 11/26/2006, 6:52 AM
To: AA-me

Here is a good illustration from the Jatco manual
on the parts that are used for various PSRU ratios.

The 2.85:1 front planet set is currently the most popular
and power is taken from the planet carrier with the
ring gear fixed. Prop turns in the same direction
as the engine. Namely clockwise from the tractor
pilots point of view. Engine RPM limit is about
7500 RPM resulting in more power.

The 2.17:1 rear planet set was widely used and power
was taken from the ring gear with the planet carrier
fixed. Prop turned in the opposite direction of the engine.
Namely counter clockwise which is also opposite to that of
a Lycoming so off the shelf props were hard to find.
Of course the rotary engine generated less power as well
due to about a 6500 RPM limit.

A few Ross's were built for piston engines use the 1.85:1
front planet set.

Ken Welter, as I recall, is building a 3.17:1 using the rear
planet set. Power is taken from the planet carrier with the
ring gear fixed so the prop will turn in the correct direction.
Namely clockwise the same as the Lycoming. The engine RPM
limit will now be about about 8350 RPM for even more rotary power.
That is getting close to the 238 HP 8500 RPM of the stock high
power RX8 engine. Probably close to 300 HP for a P-port engine.

Both planet sets shown are 3 planet gears. The Ford transmissions
were widely used in V8 powered cars and light duty trucks
for close to 40 years. The scaled down Jatco versions were widely
used in all sorts of medium size cars all over the world including
Mazda RX7s with up to 280 HP. A few years ago Ford changed them
to six planet versions which doubled the torque capabilities
and allowed their use in the heavy duty Power Stroke Diesel
pick up truck with 650 foot pounds of torque.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.