Subject: Oil metering pump/ Mechanical fuel pump
From: Rotary Engine
Date: 11/30/2006, 7:37 PM
To: AA-me


     paul

     Do you see any reason why I can't use the shaft that turns
     the oil metering pump to drive a mechanical fuel pump. What
     I would like to do  is have a mechanical pump and an electric
     boost pump. I'm thinking of using that Ellison 4-5 throttle body.
     Now if I could just figure out how to run a mag on this thing.


     Tony

     Yes that should work.
     Kinsler has mechanical fuel pumps.
     http://www.kinsler.com/
     --
     Paul Lamar ...No rotor no motor.

Paul and Tony,
  I would avoid using the oil pump drive for a mechanical fuel pump.
Unless you are talking about a low -pressure automotive (carb) pump. If
it's a MFI pump it has higher HP requirements than I'd trust to the oil
pump drive. The requirements for the oil pump are low due to the very
small amount of oil it must move. Think about the volume, around 100X
less than a fuel pump right?
Bill Jepson

It would be low pressure if it were for the Ellison.
The drive shaft design is also over kill. But to be on the safe
side drive it with a cog belt and then you can control
the pump RPM, pressure and volume of fuel supplied
by changing the pulley ratio.

Paul Lamar ...No rotor no motor.



Bill an Paul

But isn't fuel far less viscous than oil? why would it require more HP?
Plus! the oil metering pump pushes that oil into very small jets right?
Is it atomized to a degree or is it like a drip system?

Tony



Paul,
I would agree with Bill on the prohibition against using that metering
pump drive to power a fuel pump.  Most low pressure mechanical fuel
pumps are diaphragm types and the fuel pressure is produced by a spring
acting on the diaphragm.  The mechanical drive for the pump is usually
from a cam that "resets" the spring against the fuel pressure.  The
torque load, therefore, would be strongly pulsating.  The oil metering
pump on the other hand, is a tiny variable displacement vane pump that
operates against essentially zero pressure (because it is a dribble system).

Aubrey

I don't think that is the kind he is talking about.
 The aircraft style
boost pump has vane's that slip in and out of a slotted
rotating drum for lack of a better description.

The Kinsler pump is like that as well.

The drive design is way over kill for the metering pump.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.