If you have a drill press you have the basis of
a low cost mill or drill press for doing small
things like this needle valve.
The trick is to buy what is known as a compound slide.
http://www.use-enco.com/ They sell from $80 to $250
Where as the cheapest small three in one machine
is about $1300 and very small light duty mills and
lathes are about $600. If you get lathe model 110 0800
it will do tapers.
The compound slide can hold the cutting tool when
doing lathe operations. You feed the part past
the cutting tool with the drill press feed handle.
Won't do tapers however.
When doing milling operations you lock the drill press
feed handle with the end mill inserted in the drill press
chuck.
The size of the part you can do lathe operations on is
limited by the size of the drill press chuck and the rigidity
of the whole lash up. A real heavy duty drill press will
help. The chuck size limits the size of the end mill.
OK for plastics and aluminum but very small steel parts
like this SS 316 T for the needle valve might be OK.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.