Subject: aircraft rotary engine news letter
From: Rotary Engine
Date: 12/10/2006, 12:52 PM
To: AARotary Engine



Paul,

I did not intend to infer that I wanted to use the turbo Rx8 engine
because it develops 390 hp at 7400, rather because it would develop
aprox. 300 hp at the max torque rpm of 5500 to 6000 rpm.  Using a 2:1
reduction gear, it would be reliable power at a usable rpm and not
overtax the engine.  After the dyke delta that my brother and I want to
finish, I have my eye on an XL RG Velocity, which can use between 300
and 350 hp to achieve a great cross country cruise speed.  I prefer to
use the renesis rotary normally aspired for the delta.  200 hp works
best for the delta, according to John Dyke when we purchased the plans
from him.  A 3 rotor wankle would produce the same power as a renesis
turbo, but at a higher fuel consumption.

Sorry if my entheusism for the turbo renesis engine was overstated.

Chuck Spry

A couple of mis conceptions. RPM does not affect the rotary
like it does a piston engine. The rotary is more akin to an
electric motor. The RX8 engine is red lined at
at 9000 RPM and most people are running a 2.85:1 gear reduction.
At 2700 prop RPM that is 7700 RPM which is a comfortable
take off and climb out RPM for the rotary. Still far from red
line.

At cruise the bearing loads are a minimum at 6000 RPM
and the BSFC is also a minimum. In case you have not heard
of BSFC it stands for brake specific fuel consumption
and is measured in the number of pounds of fuel burned
for each HP generated in one hour. Leaned out properly
the rotary number is .47.

For example say you want to cruise at 150 HP. In that case
you will burn .47 times 150 or 70 pounds of fuel per hour.
Since fuel weighs about six pounds per gallon your fuel burn
will be about 11.7 gallons an hour. This is about the same as
most aircraft engines running at the recommended 50 degree EGT
rich of peak. It is about 5% worse than an AC engine running
at 50 degrees EGT lean of peak. Not recommended by Lycoming
but some people do it anyway. The big saving is the ability
to run cheaper auto fuel which most late model AC engines
cannot do.

BTW BSFC does not care how many rotors you are using.
A three rotor will burn the same number of gallons an
hour while generating 150 HP as the two rotor does while
generating 150 HP. Very close. Perhaps a very slight
difference.

With a gear box torque can be what ever you want it to
be. It takes HP to fly an airplane and not torque.
If it is torque you are looking for the rotary has
very little. About 160 foot pounds. However a
2.85:1 gear box increases that at the prop to
456 foot pounds.

The rotary is very reliable at 6,000 RPM. To my knowledge
nobody has worn one out yet in an aircraft. TBO is anywhere
between 2000 hours and 20,000 hours depending on what type
of apex seals you are using. Expensive ($200 each) ceramic
apex seals do not appear to wear. One reason is the apex
seal, unlike a piston engine piston ring, does not stop and
back up twice every revolution. There is a lot more info
on the web site below.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.