Paul,
Here is a rough concept model of a proposed fuel pump mount. Not shown is
the belt itself or idler arm and belt tension pulley. The 4 mounting holes
are not correct.
The device could be used in several ways:
1. Use the oil metering pump shaft as a PTO.
It would be bolted to the location where the oil metering shaft protrudes.
Assume another longer shaft would have to be fabricated. If this shaft turns
the correct way* we only need another a 2:1 ratio reduction. The shaft
collar on the mounting plate should contain at least one bearing. The pump
collar however has a front and back bearing and independent slotted shaft.
Not shown is the idler arm for maintaining belt tension. This plate would
position the pump under the water pump and clear of the housing. The pump is
free to be mounted in any 360 degree angle orientation.
2. Use an e-shaft mounted pulley,
The plate needs to be made to hinge on one of the free accessory mounts
pivots and needs an additional belt tensioning arm. Only the pump side
collar and pulley is needed. The pulley ratio must be about 4:1 or higher
however.
* Maybe we got lucky this time:)
Doug Fir
I think you want to use a cog belt for a positive
displacement pump. No tensioning required.
Paul
For your information the Brass Fluid-o-tech graphite vane pumps are about
$81.00. The bypass valves needs to be opened rather far to get the flows
you want. One question is if carbon graphite will react with gasoline or
its additives. That could be answered with a call to their Conn. office.
http://tinyurl.com/y9daap
Doug Fir
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.