I have come up with a way of pressure potting P-ports.
This will guarantee they don't leak. Requires a bit of fabrication
of a fixture made from a little bit of Lexan and a hand tire pump.
Use 10-32 threaded rod to bolt it on the rotor housing.
The same tool can check the cured P-port for coolant
leaks up to 30 psi. I am in the process of building it
and trying it out. Here is a 3D of the idea.
You put a small quantity of JB Weld in the rotor housing.
Just enough to fill about one quarter of the cavity volume
and cover the tube on one side.
You then bolt on the fixture with a rubber gasket and a bit of
wax paper on the bottom to keep JB Weld off the Lexan so it is
air tight. You then slowly apply pressure
and watch the JB Weld just start to squish out around the tube
both inside the rotor housing and out side the rotor housing.
Release the pressure quickly and let the JB Weld cure. You can
use the fast cure stuff if you wish. After it is cured you do
the other side the same way. After that is cured you remove
the fixture and add more JB Weld to the first side. Re pressurize.
If it holds the pressure you are home free. If not it will squeeze
out through any remaining leaks. Remove the pressure and let it
cure. Do the same thing to the other side. Repeat if necessary.
BTW I baked a left over cup puck of JB Weld in the oven at 350 F
and it lost a bit of hardness but it was no where near melting
or loosing it's strength. When it cooled off it regained its
hardness.
-------------------------------------
Went shopping today and bought the stuff for potting
another P-port. Looks like 3/8" thick Plexiglas is
about right for the covers. This is a 4" by 8" sheet
but 4" by 6" should work fine. The plastic shop in Burbank
cut it for me no charge. This stuff can be bought from McMaster
Carr as well. Get a special drill to drill plexi. The tubeless
tire valve is called a metal valve at Pep Boys but any tubeless
tire valve for a mag or aluminum wheel should work.
The more I think about this scheme the better I think
it will work. To do two rotor housings I am going to
cut four pieces of plexi so both can be done at one
sitting.
More about this in the next few days.
--
Paul Lamar ...No rotor no motor.
Looks good. Let us know how it turns out.
Doc Custer
Retired Software Engineer and sometime Audiologist
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.