Paul et al
When looking at the weight charts, and at the
Rotaries, it would seem there is more room for weight
loss. For example, I'm looking at cast magnesium to
replace the housing.
Once you reduce the weight of the housing only the
rotor and the shaft remain. Now the shaft will
probably be the most difficult. Probably leave the
shaft alone in a weight reduction.
Has anyone given consideration to reducing the weight
of the rotor itself? What are the limitations in doing
so? For example, the use of disimilar metals and
heating can create problems.
But a lighter rotor would allow higher RPM (and
probably create a higher idle speed).
Currently, the racing folks take off only a few tenths
of pounds on a 14 pound rotor. Ideally, I'd like to
remove up to 6 pounds off that rotor using lighter
weight metal matrix (Mg-Boron) or perhaps even a
ceramic.
So, how do I reduce the weight of the rotor?
David
The rotor weighs about 9 pounds not 14 pounds. I think a composite
might work. Aluminum rotor with cast in steel inserts for
the apex seals.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.