The rotor weighs about 9 pounds not 14 pounds. I
> think a composite
> might work. Aluminum rotor with cast in steel
> inserts for
> the apex seals.
>
> Paul Lamar ...No rotor no motor.
Paul
You are correct...9.2 lbs.
The folks as Mazdatrix(
http://www.mazdatrix.com/)
reduce the rotor weight of an RX-8 rotor to 9.0 by
machining weight just inside the three "corners".
So my target weight would be...6.0 lbs, but any weight
reduction the further from the center the better.
David
David, is this for aircraft use? The best, most economical and simplest
would be to do the end housings and intermediate housings in plain old
ALUMINUM with a good coating, or to be really exotic a cermet and ground
casting that is hard enough to run as is. There is really no reason to
lighten the rotors at all. it is a part that WORKS now. In an aircraft
you will never be using a high enough RPM that any rotor weight
reduction would be helpful.
The only person that needs a lighter rotor
is the racer revving the engine to 10K RPM or higher. If you feel really
flush cast the rotor in Titanium alloy 1/3 or more lighter with no loss
of strength.
Side/end plates are where the real weight loss is to be
had. Mazda has even done the parts already, published a paper on it and
everything! The LeMans engine used detonation gun coated and diamond
ground end and intermediate housings. They ran 24 hrs flat out and won
one of the worlds biggest races over all. This is also the safest way to
lose weight off the engine, it has already been tested by the factory!
Foamed metal and all this other stuff is fine, but getting something to
market is the key.
A rotary with aluminum end and center housings would
have such a HP to weight advantage it isn't even funny.
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.