Scroll down on this picture.
The main weight saving on a 20B would be to switch
the end housing from cast iron to aluminum. On the 20b that
could be as much as 75 pounds.
--
Paul Lamar ...No rotor no motor.
Paul,
My single rotor is now 90lb naked, adding radiator and oil cooler with
10lb
is 100lb at estimated 115hp(hopefully). Even at 100hp it would beat
everything else, just like the other rotaries.
Richard Sohn
N2071U
Richard,
What are you hoping to get out of a single NA, I can't remember if your
doing PP on your proof of concept engine. I would estimate about 115 - 125
hp for a single PP, set up right.
For a turbo ?
I'm following your development with a critical eye and it's all looking
very
good, however those pesky bolt hole positions are a bugger to get right!!
George (down under)
I don't think you are getting all the attachments George.
Did you not get this one on Richards engine?
Paul Lamar
Thanks Paul, I don't remember seeing that one!
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.