Subject: PSRU design using sprint car parts.
From: Rotary Engine
Date: 12/28/2006, 6:55 PM
To: AARotary Engine



    > This is a low cost PSRU because sprint
    > car parts are mass produced and therefor low cost.
    > They are mostly aluminum and magnesium for light weight.
    > The rear axle in a sprint car is called a live rear
    > axle because there is no axle housing. The entire axle
    > is one long piece of three inch diameter thick wall
    > aluminum tubing. Sprint cars take a heck of a beating
    > as they run on potholed 1/2 mile oval hard clay race tracks.
    > The stress on this three inch diameter half inch wall tube used
    > as a prop shaft is very low so it should last forever. It is machined
    > from a four inch diameter one inch wall aluminum tube.
    > The Ford six planet carrier is merely bolted on the back end
    > and a stock off the shelf low cost 42 splined sprint car rear
    > hub is used for the prop flange. The shaft with a 2 inch hole
    > and a 1/2 inch wall thickness weighs only 8.7 pounds.
    > Don Dunbar's steel output shaft and flange weighed 7.26 pounds.
    > Tracy's prop shaft with bearing and flange weighed 9.25 pounds.
    >
    > http://www.sanderengineering.com/cat24.htm
    >
    > The housing can be tig welded from telescopic aluminum
    > tubing and 1/2 inch plate and designed to bolt inside a
    > stock Mazda bell housing.
    >
    > http://www.argylein.com/cgi-bin/search_dies.pl?words=TUBE
    >
    > The prop shaft bearings themselves can be Torlon roller bearings
    > widely used in racing sail boat winches and blocks.
    > Torlon roller bearings will run directly on hard anodized
    > aluminum. No heavy bearing races required. Torlon is
    > 25% of the weight of steel roller bearings.
    >
    > The thrust bearings are conventional needle bearings.
    >
    > http://www.drakeplastics.com/torlon_4435.php
    >
    > My guess this could be made for under $1000.
    >
    > Paul Lamar ...No rotor no motor.
    >
    >Paul

   It looks like we could use that other input shaft on that rear end
   as an accessory box shaft maybe to turn an alternator or fuel pump
   whatever.

   Tony

   I am not suggesting we use the entire rear end as a PSRU Tony. It weighs
   probably about 100 pounds. I just want to use the aluminum axle and
   flange technology. Forged steel flanges are expensive. Tracy uses a
   forged axle and flange out of a drag racer rear end.

   Paul Lamar ...No rotor no motor.




I'm not sure just what a "sprint" car is, who makes it and it's other
parts.  Can you enlighten me?

Allen Slominski
Houston, TX

Here are some pictures of Sprint Cars. They are 850 HP V8 powered racing cars that weigh
about 1300 pounds for an unequaled power to weight ratio. Very popular form
of oval track racing all over the US. http://www.ascsracing.com/

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.