Subject: Diesel turbo charger turbine & compressor power
From: Rotary Engine
Date: 12/30/2006, 8:46 PM
To: AARotary Engine



   I just ran across these interesting charts from
   a tech paper Caterpillar did on turbo compounding
   diesel engines. Diesel engines have way less waste
   heat/HP/kinetic energy in the exhaust than gasoline
   piston engines and rotaries. Despite this they were able to
   reduce the fuel consumption as much as 10% at sea level and
   full power at 1800 RPM.

   --
   Paul Lamar ...No rotor no motor.

Paul,

I am a neophyte to homebuilt aircraft and am looking at a couple of
designs that I want to use the rotary with.  Info I have read seems to
say there is a bit of wasted charge sent out the exhaust.  I've been
trying to keep up with your turbo compounding theories and I must say it
is very intriguing.  Is something akin to this setup Caterpillar has
designed feasible for the 13?  Is it cost effective and would it be able
to be engineered into a homebuilt?  I'm not sure of the 13's exhaust
temperature but I know that it's pretty high.  Would it need to be
cooled prior to entering turbine or is it more feasible to use exotic
metals on the turbo's intake section?  I'm presently looking at the
Bearhawk and the Bede Corps BD-4(preferable).  I'm not an engine "type"
guy, but have no qualms learning my way into that category.  Thanks
again for all the work you do and information that you disseminate.

Allen Slominski
Houston, TX

Well the exhaust energy is a bit higher for the rotary than it is
for a piston engine but only about 5% or so more. Say 50% rather
than 45%. The big difference is two thirds of the exhaust energy
is dissipated by the exhaust valves in a piston engine. All engines
have a heat balance where the percentages of the energy in a gallon
of gas is distributed to various systems in the engine.
I assume you have read  http://www.rotaryeng.net/turbo.html

Building a turbo compound yourself is very expensive. I have
spent $7,000 on the project so far but I have a few contacts
in the aerospace biz and they tell me a large company is working
on it for small UAV rotary engines. Plenty of tech papers have
been written on the rotary turbo compound. Mostly computer
simulations. Most are very positive. So far no rotary based hardware
has been built to my knowledge yet.

I am waiting  until I get more info from that source
as it will save me doing a lot of very expensive R&D. Hopefully it
will not be classified.  If developed for the worlds cars a
theoretical 20% in fuel consumption world wide is possible. If you
can't wait and want to try it yourself I will give you all the help
I can including loaning you my $7,000 turbo charger gear box.

The technology is 70 years old so it should not be all that
hard. Yes you can cool the exhaust but in theory that wastes
some of the energy in the exhaust. Better to deal with the
heat. One way is use a thermo pile ahead of the exhaust turbine
to extract some of the heat as electrical power and cool the exhaust
a bit. http://www.harvestfields.ca/etextLinks/16/05.htm


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.