I just ran across these interesting charts from
a tech paper Caterpillar did on turbo compounding
diesel engines. Diesel engines have way less waste
heat/HP/kinetic energy in the exhaust than gasoline
piston engines and rotaries. Despite this they were able to
reduce the fuel consumption as much as 10% at sea level and
full power at 1800 RPM.
--
Paul Lamar ...No rotor no motor.
Paul
I would strongly recommend this type design as apposed to the direct drive
shaft off the turbocharger. I realize the direct drive may be lighter, but I
firmly believe that a second turbine for the recovery is the quickest and
safest way forward, as it has been proven and eliminates the development
time necessary for a solid very high speed shaft and any other unforeseen
issues that we have not taken into account.
Giff Marr
The fact of the matter is most car turbo chargers are putting
out twice the power necessary for the compressor alone.
This is done for compressor acceleration reasons. Rapid
acceleration of the compressor is essential for car applications.
It is far cheaper and lighter weight to take advantage of this
fact if it can be done. Also there are some heat losses in
the first turbine. We know a second turbine will work.
Too easy :)
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.