Subject: Taking power off the rotor.
From: Rotary Engine
Date: 1/9/2007, 9:06 PM
To: AARotary Engine




At the present layout of the Rotary, the crankshaft rotates three times
rotor speed and the housing is stationary, in theory there is no load on
the 2:3 gearing between rotor and housing. ( in practis there is due to
vibrations).


Could gearing changes be made to reduce the e shaft to a (2/3*2.85) without
the psru (I.e. direct drive) or are the teeth too small (or big) etc...?

Kevin Lane

I am stunned Kevin. You are kidding right?
Well I guess you are not. I am amazed that people don't
understand why the ratio MUST be 3:1. I guess I take too much
for granted. Tim Kern, who writes for Kitplanes asked me a
similar question. The mis understanding of the rotary is more
widespread than I thought. Most explanations and mine in
particular gloss over these points.

It is a mandatory mathematical relationship for the definition
of a trochoid.

http://mathworld.wolfram.com/Trochoid.html


Here are some scans from Ansdale book showing what MUST happen
IF you change the ratio.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.