Subject: The gear ratio question (2)
From: Rotary Engine
Date: 1/10/2007, 12:15 PM
To: AARotary Engine


    Hi Paul,

    Maybe in a few words I can clarify the gear concept. You've said this
in
    different words before so if I'm too far off base please edit.

    The gears inside the rotary are a means of  "timing"  the position of
    the rotor. Very much akin to the way   "timing"  gears ( or chains or
    cog belts )  "Time"  the position of the CAMshaft in an auto
    engine.  *** POWER is not transmitted in either case, only the exact
    POSITION is determined.***  This  "timing"  is necessary to put the
    piston engine valves in the proper place at the proper time, in the
    rotary this  "timing"  is necessary to put the rotor in the proper
    place
    at the proper time.

    Concept any clearer or did I muddy the waters even more.
    Dave

    Excellent. Much better than I could have put it. Very concise.

    Paul Lamar ...No rotor no motor.

Yes..  That is very good.  Can I help with the language?

The gears inside the rotary are a means of  "timing"  the position and
orientation of the rotor.  This is very much akin to the way
"timing"  gears ( or chains or cog belts )  "time"  the position of the
CAMshaft in a piston engine.  *** POWER is not transmitted in either
case, only the exact POSITION is determined.***  This  "timing"  is
necessary to put the piston engine valves in the proper place at the
proper time.  In the rotary this "timing" is necessary to put the rotor
in the proper place and orientation at the proper time.


Matt-


I'll still act dense here.

It seems that "timing" (except ignition timing, which can be handled in many
ways) is a function of the placement and shape of the ports. Since the ports
are open and closed by the position of the rotor and the rotor will go as
fast as its load, design, and inputs allow it, where is the "timing" issue?

Ports will be open whenever the rotor isn't blocking them, unlike the valves
in a piston engine, which will open when the camshaft says. If a cam belt or
chain slips a tooth, valve timing will change; what can change in a rotary?

Tim Kern

Nothing. If it slips a tooth it will jam. Extremely rare occurrence.
Far less of an occurrence than a cam changing timing due to worn
teeth. Engine can be over hauled several times without replacing
the static or rotor gear.

BTW p-ports never close. As the chambers comes by the ports two
chamber can be open at the same time. The rotary is closer to a
continuous combustion engine (jet) than it is to a intermittent
combustion (piston) engine.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.