Subject: The gear ratio question (2)
From: Rotary Engine
Date: 1/10/2007, 5:16 PM
To: AARotary Engine


Maybe I can try again...  Requoting:

The gears inside the rotary are a means of  "timing"  the position and
orientation of the rotor.  This is very much akin to the way
"timing"  gears ( or chains or cog belts )  "time"  the position of
the
CAMshaft in a piston engine.  *** POWER is not transmitted in either
case, only the exact POSITION is determined.***  This  "timing"  is
necessary to put the piston engine valves in the proper place at the
proper time.  In the rotary this "timing" is necessary to put the
rotor
in the proper place and orientation at the proper time.

  >From dictionary.com <http://dictionary.com>: Timing: 1.the system
of
those sequential relations that any event has to any other, as past,
present, or future; indefinite and continuous duration regarded as
that
in which events succeed one another.

"Timing" in this context is not about seconds, minutes, or hours so
much
as it is about the precise order in which things happen.  "Timing" an
engine is about degrees of rotation of some shaft in the engine,
regardless of RPM.  This means that "timing" is not about "time," but
about the order of operation.

So, rewriting the above...

The gears inside the rotary are a means of  controlling the position
and
orientation of the rotor within the housing.  This is very much akin
to
the way timing gears ( or chains or cog belts )  "time"  the position
of
the CAMshaft in a piston engine.  *** POWER is not transmitted in
either
case, only the exact POSITION and ORIENTATION of various pieces are
determined.***  This  "timing"  is necessary to put the piston engine
valves in the proper place at the proper time.  In the rotary this
"timing" is necessary to put the rotor in the proper place and
orientation at the proper time.  The gears force the rotor to be
oriented correctly at any given position of the e-shaft in order for
the
combustion cycles to take place.


Other things to consider:

Without the correct gearing, the rotor would be free to rotate on the
e-shaft.  This would allow (among other things), depending on how the
rotor was oriented, gases to travel from above one rotor face to an
adjacent face by passing around the end of the apex of the rotor.

Many piston engines will "jam" if the cam slips a tooth - a valve will
contact a piston.


Regards,

Matt-

Nice re-write.  To be absolutely correct, however, I think that the
static and rotor gears only control the orientation of the rotor -- the
position of the rotor is dictated by the lobe of the e-shaft.  So the
timing analogy would be something like "the gears are analogous to the
timing chain, in that the gears control the orientation of the rotor at
the various points of the rotation of the e-shaft, just as the timing
chain controls the position of the valves at the various points of the
rotation of the crankshaft."

Russell Kent


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.