An RX8 engine can be intake p-ported and use the side exhaust ports.
Don't forget there are two RX8 engines. Four port low power
and six port high power. Paul K has a four port low power.
The P-port will generate more power in the aircraft 5000 RPM to
top RPM through out the range. In theory the p-port will have
slightly lower fuel burn. Not proven yet in aircraft. Mazda won
LeMans with a fuel limitation using p-ports.
Paul Lamar ...No rotor no motor.
Paul(s),
I also selected the 4-port, 210 hp ("low power" from the automatic RX8)-
because I wanted the flexplate and weights to be compatable with Tracy's
redrive, and because my Plane is a 9A, which is designed around a 140-160 hp
engine. The low power version is already significantly more powerful than
required, and its intake design is easier than a 6port. The Renesis was
designed to provide better low end torque along with higher top end power to
compete with the high tech v-8's and techy Japanese 6 powered sports cars
the R-8 competes with, and to provide better fuel economy in the process. I
have no idea how much of the complicated RX8 intake I removed is responsible
for the improved drivability and efficiency vs the port and rotor
improvements.
With a meager wisdom base, Im thinking that most of the normal flight
envelope will occur closer to 5000 rpm cruise than at 7000 full power
(6000rpm is my target); therefore the 4port seems the better choice for MY
use than either the high power Renesis or a p-ported 13B. If 250-300+HP is
needed (as in a RV-10), the p-porting makes a lot of sense, but then, so
does turbocharging or better yet, a move to the 20B. Being rediculously
critical and splitting hairs, I see some benefit with the p-port 13B and
high power Renesis above 7000 rpm (with a major fuel burn cost), about the
same mid range performance 5000-6000 rpm, and probably some detrament
(roughness) due to exhaust gas contamination of the intake charge at lower
speeds with the P-port.
Id like to thank Paul L for his excellent chart support and ideas- they have
greatly helped put some level of sanity into this powerplant selection
process. Im extremely interested in your turbocompounding experiment- the
perfect muffler. I like your idea of p-porting for the intake due to
overall simplicity- the big question is whether the effort is worth the
benefit.
MICHAEL D PARKER
Good point on the flex plate. Also don't forget Paul K has a
Glasair which cry out for a powerful engine. For an RV9 just
about any rotary would be fine. The big problem is coming up
with an intake manifold tuned for 5000 RPM in your case.
The stock RX8 intake manifolds low power or high power are
way too bulky.
That is going to take runners somewhere in the range of 28 to 30
inches. If you are going for cruise BSFC you want the torque
peak at your cruise speed. I assume you have a 2.17:1 PSRU.
Right now I don't have an entirely satisfactory answer for that.
Certainly nothing cheap and easy to make.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.