Subject: rotor oil cooling hole.
From: Rotary Engine
Date: 1/12/2007, 3:32 PM
To: AARotary Engine





hi Paul and all,      i need a little help.    am about to cut some
single rotor e-shafts and have one problem.  i will move the location of
the hole to the low point of the lobe and just clear of the fillet at a
shallower angle than the original. some one on our newsletter a long
time ago said to open up the jet to 2MM.  however the jet is only about
1/8" long and i will be drilling through slightly over 1/2" should i
increase the size of the hole and how much, to supply the proper amount
of oil?     thanks a bunch    wyo. walt.

That has not proven to be necessary in an aircraft engine.
Perhaps an out and out car racing engine but there lots flying
with the stock oil jets. Will that help? If not send me some pictures
so I can get a better feel for the problem.
-- 
Paul Lamar ...No rotor no motor.


I do not see why you want to move the oil jet location. I am using the
original location and jet in the single rotor. Never had a problem or found
a disadvantage on  the engine.
Is in your design something in the way of the original location?
If it ain't broke don't fix it!

Richard Sohn
N2071U



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.