Can a RX-8 oil inj. port be used as a fuel inj. port?

milo

Interesting idea. Perhaps it will work. Four FI ports
so it has the redundancy required.
-- Paul Lamar ...No rotor no motor.

Paul please run my question again, thanks.
Does any one have information about the possibility of using the oil
injection in port being used as a fuel injection in port on a RX-8 engine?
It would appear that a small fuel injector can be installed in the oil
injection in port, without modification of the rotor housing, but am not
certain what is down stream in the rotor housing. Any help would be
appreciated! bmb

Paul & Milo,
The real question is are the ports big enough at the inside? If they are
using the same thread and you plan to mix oil in the fuel they should
work. You might have to open the port up on the inside of the rotor
housing to allow the fuel enough room to atomize. The holes are near the
side of the housing which might cause rough running at low speeds due to
the fuel and air not mixing as well. That is the biggest problem I could
think of.
Bill Jepson


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.