This is my  attempt at a six opening slide throttle mounted on the lower
half of the intake manifold. I have some .032" teflon sheets that I will
mount between the base and slide. I will have the slide base tack welded
to the intake manifold and either alumabraze the rest or seal it with JB
weld. I am mounting a boss on each of the outboard intake tubes for
extra low pressure fuel jets distribution. If the dribble system doesn't
work out I can go back to the EFI.
   I cut the water pump hose barbs off at a 20% angle and made 15%
fillet pieces to angle the inlet and outlets down enough to clear the
inside of the engine mount and cowling.  Karibian


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.