This is a winner. Losing the strut is no big deal since the ability
to fine tune engine pitch is retained.

  People who are new to this list would be amazed at the five year
history of the evolution this design.  Paul has probably drawn a
hundred iterations. Over time,  the engine mount got better, slowly,
but it has not been easy.  This mount is light, incredibly strong,
and it is OUT OF THE WAY of other engine components like the exhaust
system.  This engine mount was engineered by Paul, without
compromise. Even though I have asked him on many occasions to fudge
just a little, to make things easier, most of the time  he did not
seem to hear. Other times when he definitely did hear, I received a
smoking e-mail setting down the law.

  This engine mount is designed  to provide space to put the radiator
under the engine with a properly shaped intake plenum.  To do that,
the oil pan had be redesigned and it has become a functional part of
the engine mount both because it is the anchor for the rear beam and
because of its shape.   Anyone can just buy the engine mount and get
on with his conversion.  No big deal now, but to those of us who have
had a part in bringing it to where it is today,  this last iteration
is MAJOR.

Paul,  if you have time, in the attached drawing change the center
section to 6.5 inches as we discussed and also indicate the angle
between the arms and the center piece.  I want to start building the
fixture for this piece tomorrow.      Thanks,  Jerry



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.