paul jerry asked me to forward this to you he was going to be
off line. top bolt holes center to center is 40 1/4'' bottom
bolt holes center to center is 403/8'', from bottom of lower
mount to top of upper mount is 29 1/8'' these from inside of
hard points ( these are inside the square tube measurements )
if i confuse you yell back and ill fax you a picture .
thanx bobby c
Thanks Bobby but I don't need them as I have a set of BD4 plans.
Paul Lamar ...No rotor no motor.
Why does he say the top spacing 40 1/4"? The top and bottom
spacing is the same. Unless this is as built for Bobby's plane.
Those top brackets will flex that much anyway.
Bob W.