paul jerry asked me to forward this to you he was going to be
off line. top bolt holes center to center is 40 1/4''  bottom
bolt  holes center to center is 403/8'',  from  bottom of lower
mount to top of upper mount is 29 1/8'' these from inside of
hard points ( these are inside the square tube measurements )
if i confuse you yell back and ill fax you a picture .
thanx bobby c


Thanks Bobby but I don't need them as I have a set of BD4 plans.

Paul Lamar ...No rotor no motor.

Bobby, can you send me a photo of the hard points on the firewall?
Jerry


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.