Attached is a drawing of the proposed 20B slide throttle slide.

I arrived at the placement of the 3rd induction hole by taking the
3.153" for the unique side housing and adding 80mm or 3.14961" for the
two rotor housing halves. This results in 6.303" as shown on the drawing.

Is this correct?

Doc Custer
Retired Software Engineer and sometime Audiologist

No attachment came through Doc

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.