Paul-

Getting ready for the return of my engine, and I need to get the welding
on my exhaust reworked.  Based on prior discussions here on the list, I
know I must get the exhaust tubes rewelded to the inside of the mounting
flange.  Before doing this, though, do I need to remove the exterior
welds, or are welds on both the inside & outside acceptable?

Mark

The heat damage is done already to the metal alloy. Can you
shorten them about 3/8ths of an inch and just weld them on the
inside?  Are they 321 SS and .065 thick?


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.