I was involved in the Exhaust industry for a number of years including
designing the odd muffler.
What Paul says is true, however the one thing not mentioned is just
how
bad this style of design is
it will allow exhaust gas flow that's about it, this is what is
nicknamed a "back pressure" it is
unbelievably bad in gas flow which = HP which means increased fuel
consumption by quite a bit,
My suggestion is do not use this style design at all. It is one of the
worst designs there is.
It will shut things up but , it will run a lot hotter, create
excessive
back pressure, increase fuel
consumption & reduce horsepower just to name a few things all of which
you really do not want!
Sorry. I just had to stress this.
Try another style. While not the best option it will work somewhat
better if you use the can with out the tube
in the middle try to improve the tube curve into it, and use the pipe
out it bigger the better within limits in the
same place, while not the most efficient it is better than with the
perforated tube in the middle it will also last a while
and yes use at least 2 or more support straps to stabilise it and to
ensure if it breaks it stays right there you
will hear it if it breaks.
Regards David
Hi David,
So it happens I'm involved in the aircraft exhaust systems industry
for the last 6 months. Got to inspect and certify hundreds of
different systems. From all of these only one was welded on the
inside of the flange. I don't know why, but all of them are welded on
the outside? Just a fact.
Regarding the back pressure: Flew with straight out pipes for 2
hours, than with my new muffler. Did not notice any loss of power?
The straight pipes were unacceptable for noise reasons, and they were
activating my headset microphone in flight. There are tradeoffs for
everything, and I'm happy with this one. For my PP engine I may go
with a better? design.
Thanks for your input.
Buly
A lot of piston aircraft engines don't have the same
problem we have. The pipes comes straight down from the cylinders
to the muffler. The bending loads, if any, are low. There are
four or more pipes supporting the weight of the muffler in tension
and not bending under the engine. Our mufflers are cantilevered
off the side of the engine. In the case of professionally made AC
mufflers systems the parts may be heat treated to minimize the
effects of welding.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.