Subject: Exhaust Welding Bulent pusher.
From: Rotary Engine
Date: 2/2/2007, 8:56 AM
To: AARotary Engine


Paul & Bluey,

    I've been reading about the exhaust header cracking and thinking
about my motorcycle riding/repairing days and wondering if the method of
attachment used on motorcycle headers could be applied to the rotary...?

The motorcycle headers use diamond-shaped flanges that capture the
header tubes (which have a rolled flange) to bolt the header to the
motor.  I found a picture on the Web that illustrates what I'm thinking
about.  On my Hondas, the flange incorporated fins and acted as
heat-sinks to draw the heat from the joint.
 Jack Beale

Everett Hatch used something similar.

Did you see it on this  web site?:
http://www.rotaryeng.net/exhaust.html

Paul Lamar

Anybody know of a source for a Hatch type flange?

Doc Custer
Retired Software Engineer and sometime Audiologist


Aircraft Spruce cat 2006 to 2007 page 305.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.