Subject: MM tube wall dimensions?
From: Rotary Engine
Date: 2/2/2007, 8:23 AM
To: AARotary Engine


Paul,

I am getting ready to order steel tubing for the motor mount. I have the
design you did, but the 3Ds do not specify any wall thicknesses. I am
clueless! :(

There are two sizes: 0.75 and 1.5 inch. I assume these dimensions are
OD, correct? Are all the 0.75" tubes the same wall thickness?

Sorry to be so ignorant. :)

Doc Custer
Retired Software Engineer and sometime Audiologist

In most cases .049 wall 4130 is fine for the 3/4 diameter.
The really bad designs require thicker wall :)
The 1.5 inch sounds like the rubber bushing holders.
They can be up to .125 wall but I think Jerry uses
.065 wall which is also fine. These motor mounts
are remarkable light in weight. The fire wall
connections use short pieces of 1 inch dia. or larger
depending on the bolts used. That is so you can get
a deep socket in there over the AN bolt heads. In those
cases .065 wall is fine. I think Van calls out a 5/16
bolt for this purpose. That requires a 1/2 inch ID socket.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.