Subject: MM tube wall dimensions?
From: Rotary Engine
Date: 2/2/2007, 9:34 AM
To: AARotary Engine



Paul,

I am getting ready to order steel tubing for the motor mount. I  have the
design you did, but the 3Ds do not specify any wall thicknesses. I am
clueless! :(

There are two sizes: 0.75 and 1.5 inch. I assume these dimensions are
OD, correct? Are all the 0.75" tubes the same wall thickness?

Sorry to be so ignorant. :)

Doc Custer
Retired Software Engineer and sometime Audiologist

In most cases .049 wall 4130 is fine for the 3/4 diameter.
The really bad designs require thicker wall :)
The 1.5 inch sounds like the rubber bushing holders.
They can be up to .125 wall but I think Jerry uses
.065 wall which is also fine. These motor mounts
are remarkable light in weight. The fire wall
connections use short pieces of 1 inch dia. or larger
depending on the bolts used. That is so you can get
a deep socket in there over the AN bolt heads. In those
cases .065 wall is fine. I think Van calls out a 5/16
bolt for this purpose. That requires a 1/2 inch ID socket.

Paul Lamar ...No rotor no motor.

Doc,  For the rubber bushing holders (I wish we could think of a name
for these things) I use 1.375 x .058 wall 3 inches long.     Nothing
wrong with going heavier/larger as long as the socket can be
inserted.   The bolt through the Barry bushing is .5 inch.  You will
need a 3/4 inch socket with  a short extension to tighten the
bolts.   One of Barry's special "snubbing" washers  is welded to the
end of the of the three inch tube. (wait to you see the price on
these)   The washers are heavily zink coated, so I burn off the zink
before welding.  The best way to do this is to hold them at orange
heat  red for several  minutes.  You will see yellow smoke when the
coating lets go.  They will still require wire brushing.   All the
tubes are either .75 or .8750 o.d. with .049 wall unless  you have a
very long run on the bottom tube.  Sometimes Paul likes this one to
be 1 inch o.d.   Since you are buying a gear mount, you don't have to
worry about the firewall side.   Hope this helps.    Jerry



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.