Paul,
I am getting ready to order steel tubing for the motor mount. I have the
design you did, but the 3Ds do not specify any wall thicknesses. I am
clueless! :(
There are two sizes: 0.75 and 1.5 inch. I assume these dimensions are
OD, correct? Are all the 0.75" tubes the same wall thickness?
Sorry to be so ignorant. :)
Doc Custer
Retired Software Engineer and sometime Audiologist
In most cases .049 wall 4130 is fine for the 3/4 diameter.
The really bad designs require thicker wall :)
The 1.5 inch sounds like the rubber bushing holders.
They can be up to .125 wall but I think Jerry uses
.065 wall which is also fine. These motor mounts
are remarkable light in weight. The fire wall
connections use short pieces of 1 inch dia. or larger
depending on the bolts used. That is so you can get
a deep socket in there over the AN bolt heads. In those
cases .065 wall is fine. I think Van calls out a 5/16
bolt for this purpose. That requires a 1/2 inch ID socket.
Paul Lamar ...No rotor no motor.
Thanks, Paul
Doc Custer
Retired Software Engineer and sometime Audiologist
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.