Subject: Make your own e-shaft
From: Rotary Engine
Date: 2/2/2007, 8:28 AM
To: AARotary Engine



     The advantage of the shaft is it makes a six
rotor engine possible.

     Kenneth McKenzie


     --------------------------
     Maybe! Good luck :)

     Here is a picture of Hurley's but I was never
able
     to find out how he did it.
     --
     Paul Lamar ...No rotor no motor.

Questionable at best. Since it is already possible
to produce a 4 rotor
using the taper connected Guru E-shaft, I don't
understand the
facination with splines. It would probably cost MORE
over all to produce
a shaft this way. The ID's would be cheaper, (if the
broach could hold
tolerance), but the exterior spline would have to be
very carefully cut
to hold a zero clearance. Even more if the entire
shaft was tapered. I'm
not just guessing here either I was a machinist for
year and did some
persision broaching. I must admit I just can't see
using it as a central
drive for an e-shaft. The multi-piece shaft
available from Guru/Extreme
Rotary allows intermediate bearings, and is
effectively solid after
bolting up. The taper is by nature a zero clearance
item. Cutting and
grinding an e-shaft should be easier than making a 4
cylinder
crankshaft! There are lots of places with the
machinery to do this.

There is no established infrastructure for the
spline parts. It may
work, I'm not putting down the idea. The point is
that it isn't going to
be FUNCTIONALLY better, and could be much worse if
not done almost
perfectly. So, if it isn't a lot cheaper or easier
why bother? A high
performance (P-port) 4 rotor could put out 400HP
without even breaking a
sweat. 400 HP from a package even smaller than a 20B
due to the use of a
standard intermediate (center) housing would be
tough to beat. I must
admit I am intrigued enough to think of selling my
20B to build one.
This is with parts that are available NOW. Hard to
overcome the "now"
part with a new and unproven concept. Kenneth you
would spend a great
deal of money making this work, and would have few
takers until you
could show a engine with hundreds of hours. Go
carefully if you try.
Bill Jepson

Bill
The reference to taper was for the broach part not the
eshaft.
Robert


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.