Subject: Make your own e-shaft
From: Rotary Engine
Date: 2/2/2007, 5:47 PM
To: AARotary Engine


Gentlemen,
I agree I did not follow exactly what you are trying
to do.
Sorry if I said something silly.

All I was saying is that 500 ftlbs of torque require
a larger than 1"
solid shaft,
even if made out of higher grade shafting material.
The G-Modula, or
springiness
of the various steels does not change with their
ultimate strength,
although their load capacity does.
But often vibrations lead to breaks, not the torque
load.

If the torque is not smooth then an additional load
factor must be used,
depending
on the torque fluctuations of the source. With a six
rotor unit the
fluctuations are not
as high as from a two rotor. But still, 20 or 30 %
should be added to
the torque.

Rolf

Kenneth
I checked with an ME friend about your comment that
the journals and lobes would add strength to the
splined shaft. He said they would contribute little
and the majority of the torque introduced into the
shaft by the lobes would be carried by the shaft. With
the stress formula provided by Rolf and your 1.182
dia, the safe max torque would be 213#'. Is this about
right, Rolf?
regards, Robert

Robert,

Yes your number is correct. (I get 216 ftlbs using PI/16 instead of 0.196.)

If the shaft is splined with a DP 24, the depth I find is .098 ".
Subtracting that from 1.182 we get 1.0836" as root diameter.
The maximum torque is then near 167 ftlbs.

Applying a factor of say 1.25, the torque applied should only be near
133 ftlbs.

Regards, Rolf



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.